Hello,

This would be my 1st indicator, how do you use it?

I imported it successfully (I was prompted during the installation that some of my local files were more up to date, so I didn't overwrite them). After that it said that the installation had been successful.

Then I went to the indicators and picked a Price Alert indicator where I can enter a specific price.

But... how will this work with every line, horizontal line, etc that I draw? I've just draw a few and there's no alert when the price closes above it?

Thank You! It works very well! However, I have a question about the message lines I get on my chart and I'm not sure how to handle. It reads "Check start and end point for your line (s). 1 or more is not eligible for an alert".

Let me know, thank you again!

AMcCullough

Many thanks, was searching for something like this ....

This works well....thanks !!...

Might be good if a continual cycle alert option rather than just one beep...also....would it be possible to add an alert for a vertical line ??...this could be very useful....

....

NT Version 7.0.1000.7

Does this work on this version of ninjatrader.

Thank you Ryan, was looking for something like this as a guidance.

Thanks for the feedback. It's currently hard coded to check for alerts only on price close value. Alerts on indicator crossing requires code change with the specific indicator used instead. Additional actions also need to be added through code, and the appropriate block is commented to indicate where.

It should work on all NT 7 installations.

Hello Ryan can you add a email alert to this. Very nice work.

Thanks