'End Date' is getting set across workspaces.

[GaryAlbers]

I have two workspaces, one where I do nightly review and development and one that I use to record live market action.

During my nightly work I used the 'Format Data Series' dialog to set a 3 day range on the 1 chart I had open in my development workspace. The End Date was 7/12.
The real-time recording workspace was NOT open at the time.

Later, I opened the real-time workspace and went to bed.

The next morning when I connected to my live data feed it, every chart in my real-time workspace had an End Date of 7/12.

This is a real pain because every time it happens I have to go through all the charts and reset the 'End Date'. Some times I did not notice the lack of activity on the charts and I went away all day only to notice at night that no daily recording occurred, because the End Date had been changed.

- Why did all the charts in a different workspace that I did not touch have their 'End Date' changed?

- Is there some global setting that causes this?

- Any suggestions?

Regards,
Gary

[NinjaTrader_ChristopherJ]

Hello GaryAlbers,

Thank you for your post.

Prior to exiting NinjaTrader did you save your Workspace with the end date changed? If so saving the Workspace will save your end date applied prior to exiting.

Please let me know if I may be of further assistance.

[GaryAlbers]

ChristopherJ,

I had Ninja up and running all night so it was not shut down at all.

Also, I did not save the workspaces across this time span.

I simply connected to my data feed and noticed that nothing was happening because the End Date was set to 7/12 and the real date was 7/13.

-Gary

[NinjaTrader_ChristopherJ]

Hello GaryAlbers,

Thank you for your reply.

I am attmepting reproduce the issue you are experiencing but am unable to.

Can you please send an email to support at sign ninjatrader dot com Attn: Chris ticket# 193466. Please include the exact steps you used so I may attempt to replicate on my end.

I look forward to assisting you with this issue.