In the last few days, the 'bar width' on one of my charts has started to change. I have all bar widths of the 6 data series set to 1 when I close and save. When I next run Ninja Trader, the bar widths of four data series load as saved, but 1 loads with a bar width of 18, another with a bar width of 8. I have attached an image of the chart window. I typically close and save the workspace from the 'Control Panel'; File/Exit then 'Yes to All' in the 'Save Workspace' Pop up. I typically have only the one workspace.
Another setting that has almost always been different than when I close and save is the 'Z Order', on a different chart, but in the same workspace. Another is the 'Column' settings on the 'Orders' page of the Control Panel. I re-order the columns, close and save, and when I run Ninja Trader, the columns are in a slightly different order.
With respect to the 'bar width' settings, if I reload the chart template, the bar widths are correct. I'm not real sure if reloading the chart template corrects the 'Z Order' settings problem, I can play with that a bit more and post again. With the Control Center column, I don't believe there is a template, they 'save' with the workspace, correct ? I have tried saving the workspace with different names, using 'save as', and I have searched my hard drive for files in different locations with the same name.
Please advise, I'm assuming this is not what Ninja Trader is expected to do.
Comment