hotkey for chart trader

[kalalex]

Hi,

I wonder why hotkeys for cancelling and closing order are not working.
I assinged ctrl+x for cancel and ctrl+c for close of orders and tried on chart trader.
Nothing happens.
Could you guide me how to set it up?
Thanks.

[NinjaTrader_Bertrand]

Is 'Use order entry hotkeys' checked under Tools > Options > General kalalex?

[kalalex]

Thank you.
It's working now

[isto313]

Setting HotKeys

Hi,
Just wanted to know is it possible to set hotkeys in this manner?

Offer $0.03 Above the Inside Ask: CTRL + up

Offer $0.01 Above the Inside Ask: CTRL + right

Sell with the Offer 1/2 Position: CTRL + NUM 9

Buy with the Bid 1/2 Position: CTRL + NUM 7

Sell with the Offer: CTRL + NUM 3

Buy with the Bid: CTRL + NUM 1

Bid $0.01 below the Inside: CTRL + left

Bid $0.03 below the Inside: CTRL + down

Sell to the Bid 1/2 Position: ALT + NUM 9

Buy the Offer 1/2 Position: ALT + NUM 7

Sell to the Bid: ALT + NUM 3

Buy the Offer: ALT + NUM 1

Select MM Box: Home

Home Cancel Last Order: CTRL + NUM 2

Cancel All Orders: CTRL + NUM 0

Cancel Symbol Orders: CTRL + NUM 5

Close Selected Position: CTRL + F

Add/Remove Title Bar: CTRL + T

Load Position Size: CTRL + P

Buy Stop Market: ALT + B

Sell Stop Market: ALT + S

[NinjaTrader_Bertrand]

Should be doable isto313, for your custom orders - please see the last section of this link going over the setup steps needed - http://www.ninjatrader.com/support/h...h_hot_keys.htm

[isto313]

Thank you very Much, I really appreciate it.

I'll see if I can figure out how to get them set up from following the instructions.

[isto313]

I searched for a place to ask this question without any luck.

I am getting pre-market data on my charts... How can I set the charts to only show regular market data. I don't like the break and the distance between regular market candle sticks. I would prefer the candle sticks of each day to be right beside of each other without any space from pre-market between them.

Thanks for your help.

[NinjaTrader_Bertrand]

That would depend on which session template you set while creating the chart, if you pick the RTH / cash hours here for your instruments, then this would be what is shown on the chart only.

You can set this under the Data Series parameters (press Ctrl + F to bring those up).

[isto313]

Wow... Thank you so much.. I have been looking for that setting for awhile now.

This is great. Have a good day!