StrategyAnalyzer not showing results

[AnotherTrader]

Please see the attached screenshot.

The summary rows at the top show all "zeros", but the "Summary" at the bottom for the highlighted line of results does show values ...

Any idea what is up?

This is 7.0.1000.26.

[NinjaTrader_CalH]

Hello AntoherTrader,

If you click on the tabs in the lower section and come back to the summary page, does it update correctly?

[AnotherTrader]

Hello AntoherTrader,

If you click on the tabs in the lower section and come back to the summary page, does it update correctly?

No, it does not seem to.

[NinjaTrader_CalH]

AnotherTrader,

Can you please test this with the SampleMACrossOver with the same settings.

Do you get the same kind of results, all zeros on the optimizer but values in the summary?

[AnotherTrader]

AnotherTrader,

Can you please test this with the SampleMACrossOver with the same settings.

Do you get the same kind of results, all zeros on the optimizer but values in the summary?

SampleMACrossover works as it should, with values both above in the optimizer and below in the summaries.

[NinjaTrader_CalH]

AnotherTrader,

Would it be possible to test out your strategy on my end?

[AnotherTrader]

AnotherTrader,

Would it be possible to test out your strategy on my end?

Sure. Where should I send it?

[NinjaTrader_CalH]

Please send a note to platformsupport [at] ninjatrader [dot] com
with ATTN Cal in the subject, a reference to this thread and your strategy attached.

[AnotherTrader]

Please send a note to platformsupport [at] ninjatrader [dot] com
with ATTN Cal in the subject, a reference to this thread and your strategy attached.

Done. Many thanks.

[AnotherTrader]

I did some more trouble-shooting, and it seems the issue arises due to some custom toolbar buttons added to the chart by the strategy. If I modify the strategy to add the toolbar buttons only during realtime trading, the optimizer display behaves as expected.

[NinjaTrader_CalH]

AntoherTrader,

That is to be expected behavior when you try to use ChartControl items or try to modify the ChartControl and then run Strategy Analyzer. Since, the strategy doesn't have a full chart built into it, it will run into issues when trying to modify the ChartControl. You can use a TryCatch statement to any modifications in which you are modifying the ChartControl/Toolbar

If you ran this on a regular Chart you do not have these issues.

Let me know if I can be of further assistance.