I am seeing that my chart data is corrupted (e.g. the bars are in consistent) if I configure my NT8 to be able to connect to 2 data providers.
In my case I subscribe to data from CQG and Kinetics. But I only connect to one data provider at a single time. Meaning if I am connected to CQG, Kinetic connection will be turned off and vice versa.
There are some products (e.g. FX futures) that these 2 providers will over lap.
I found that when I make such configuration to my NT8 (in fact it was also occurring in NT7), my chart data is not showing the correct data (e.g. if i compare to the chart on another NT8 with only a single connection such as CQG, the chart in my NT8 with 2 connections do not look the same and sometimes do not look correct at all with out comparing.)
Is there a work around for me to be able to switch between providers but not corrupting my data?
Thanks in advance
ystan79
Comment