The second tool indicator does not work.

[ArchakovDenis]

Hello! You could tell as follows: the indicator for the second instrument does not work in full volume (highlighted in yellow on the chart). I can not understand what the problem is. I attach scans.

[NinjaTrader_PaulH]

Hello ArchakovDenis,

Thanks for your post.

Please note that we have also received your two e-mails (which we have merged) on this as well.

I will investigate this and likely will have some questions for you which I will send in an e-mail shortly.

[ArchakovDenis]

Жду с нетерпением Ваши вопросы чтобы разрешилась эта непонятная ситуация.

[ArchakovDenis]

Я очень нуждаюсь в Вашем ответе!!!

[NinjaTrader_PaulH]

Hello ArchakovDenis,

Thanks for your replies.

Please respond to the e-mail I have sent to you requesting further information.

[ArchakovDenis]

You could duplicate the sending of a letter requesting additional information, since I did not find it in my mail ([email protected]). I would be very grateful.

[NinjaTrader_PaulH]

Hello ArchakovDenis,

Thanks for your reply.

Please check your e-mail junk file for e-mails from PlatformSupport. I have resent.

Also, please edit your post and remove your e-mail address as you may get a lot of spam due to the internet robots that scan for e-mail addresses.

[ArchakovDenis]

Thank! I got your letter. I took note of the information about the sending of messages and this will not happen again on my part. I answer your questions: 1. I created the code through the strategy constructor. 2. I attach the scan of the version of NT8 used by me

[NinjaTrader_PaulH]

Hello ArchakovDenis,

Thanks for your reply.

I have replied to you via e-mail and will also update this forum post for anyone looking to do the same thing. The intent was to add a secondary data series to the strategy and then plot an indicator based on that secondary data series via AddChartIndicator().

In the help guide of AddChartIndicator() we see this note that covers this situation: An indicator being added via AddChartIndicator() cannot use any additional data series hosted by the calling strategy, but can only use the strategy's primary data series. If you wish to use a different data series for the indicator's input, you can add the series in the indicator itself and explicitly reference it in the indicator code (please make sure though the hosting strategy has the same AddDataSeries() call included as well)

Reference: https://ninjatrader.com/support/help...tindicator.htm

[ArchakovDenis]

Yes, I received your letter in the mail. Thank you for your help and for your explanations. In this case, I thought I was doing something wrong. I hope that everything will change for the better !!!