Startegy adds indicators and does'nt cancel them

[fredfred]

My strategy when activated adds 2 indicators to indicator panels, but when I re-enable the strategy it adds the two indicators again but doesn't cancel the previous indicator Panel and leaves the message "calculating"
This happens every time the Strategy is re-enabled, and I end up with many Blank indicator Panels?

[NinjaTrader_Jesse]

Hello fredfred,

Thank you for the post.

I wanted to see if you can provide more specific details surrounding this situation so that I can further review this.

Was this a custom indicator being used or is this a system indicator?

Is this also something you can make into a sample strategy so that I can also test this?

Are you able to manually apply the indicator and see it calculate/work?

If you allow the indicator to calculate and then re-enable is it removed?

I look forward to being of further assistance.

[fredfred]

The indicators are custom indicators from system indicators ie, Momentum/Linear regression and Volma. I can send the strategy to you. The components are all in The Ninjatrader default set?
I can apply the indicator to see it work, and the strategy was made in the Strategy Builder and still locked in it.
If I manually put the indicators in I can remove it, but when the strategy adds the indicators, then I reenable the strategy the indicators go, but the Panel is left that it resided in. when I try and delete in indicators the message is that a strategy is using it and cant be removed.
Do you want me to send you the strategy ?

[NinjaTrader_Jesse]

Hello fredfred,

Thank you for the additional details.

Yes if this is using system indicators I would like to see a specific example of the problem to test on my end. Because you are using the builder, I would suggest doing the following to generate a test strategy:

1. From the strategy builder generate a new empty strategy
2. Create a single condition or action which uses the system indicator which fails to remove and configure it the same as you have it in the other script.
3. Run the strategy to ensure the problem still exists with the sample.
4. Export the strategy and attach it to your post.

If you can do these steps to clearly highlight the problem, that will allow me to test the script and confirm if I also get the same result. If we are not seeing the same result, we can troubleshoot other areas which may affect this, however, if I am able to see the problem we can likely find a resolution with that sample.

I look forward to being of further assistance.

[fredfred]

OK, I'll do that ASAP

Thank you