I have two simple sets of conditions in strategy builder (NT8):
SET1
Default input[1]>Open[1]
Default input[0]>Low[1]
___________________
EnterLongLimit(1, Low[1])
and the opposite for enter short:
SET2
Default input[1]<Open[1]
Default input[0]<High[1]
___________________
EnterShortLimit(1, High[1]).
Tested on ES futures, RTH trading hours, 10min timeframe; 26.3. 2018 - 26.4 2018
If I use just one of these sets, everything works good, but if I want to combine both, some opportunities are overlooked (specifically 26.3. 10:00; 5.4. 10:00; 11.4. 9:30; 12.4. 9:30; 19.4. 9:50).
If I cancel RTH settings and run the test in ETH trading hours, these overlooked trades are completed correctly, and if I use ETH and add a time condition in "condition and action", the behavior is wrong again - the same like run in RTH range.
I don´t know what´s wrong - how to test both sets together in RTH?
...And I have another (smaller) question - in strategy builder, if I use moving average from different timeframe, how can I plot it on chart in strategy analyzer?
For example:
High[0]>SMA(<Primary> (Daily), 14)[1]
_______________________________
EnterLong
If I test this condition (using intraday data), I would like to see the daily calculated SMA on intraday chart.
Thank you, I´ll be very grateful for any ideas.
Comment