Please see attached screenshots of 15min (on which Ray was drawn) and 1min (on which reproduced using Global DO).
Note toward the end of bars, above line on 15min/below on 1min. Also, intersects with HOD line on 5min, later on 1min.
My Ray Drawing Tool is set to Global by Default (i.e. I am not applying Global after drawing)
Both Charts have snap mode Bars
The line is created on the 5min
If I draw, on the 1min chart, a Ray from the HOD green dotted line 1.0090 to the top of the lower highs at 1.0068 (i.e. no bar penetrates the line), the corresponding global line on the 5min isn't faithfully reproduced either - the line on the 15min is penetrated by a bar.
Kind regards,
Bruce
Comment