I'm a relatively new point-and-click trader, and I'm very excited about the playback feature in NT. I conduct most of my analysis on a 5 min. chart. So, what I do is to run the playback at 100 times normal speed. For every 3 seconds, NT draws up a new candle on the chart, I then stop the playback and do my analysis. Before I do my analysis, I need the bar to close.
Again and again, the time counter is sliding by number of seconds, meaning that I will either not see the candle fully closes or I will have started on the next bar. Each time I then have to slow down and pause the replay to get it back into sync, so I again get a full new 5 min. candle drawn in 3 seconds. I end up wasting A LOT of time doing this re-calibration.
Is there a bug in the replay feature, or is there something I can do differently to avoid this issue?
I'm focusing on CFDs and are running the SPX500 CFD in replay mode.
Comment