Orderflow Volume Profile Drawing keeps refreshing

[david720]

I recently started using NT8 and the OF Tools in it, and I have searched for a solution to my issue before and that was to enable "tick replay" from my understanding. But whenever I put in a new drawing or make a change in any other drawing, the OF Volume Profile Drawing Refreshes, and it takes a while for it to load because I am using tick data. Thank you for any tips

[NinjaTrader_Manfred]

Hello david720,

Thank you very much for your post and welcome to the NinjaTrader forums!

I was not yet able to recreate this issue on my platform and would like to take a closer look at your log & trace files, as they should indicate any issues or errors reported. Could you forward these files to me?

You can do this by going to the Control Center -> Help -> Email Support

Please select "Platform Technical Support" as the recipient and enter a brief "ATTN 03336616" note in the message.

Thank you in advance, I look forward to your reply!

[david720]

Thank You for your reply Manfred, I may or may not have explained my issue wrong, and I am not sure if this is normal even, but even if I make the smallest change in the Properties, like keeping the Drawing Locked or Unlocked, and I hit apply, the OF Volume Profile tool just Recalculates the tick data

[NinjaTrader_Manfred]

Hello david720,

Thank you very much for the clarification.

I would expect the platform to briefly reload the drawing objects. However, even with Tick Replay enabled, this should be brief as the data has been cached and only needs to be redrawn.

I've recorded an example (please forgive the cluttered chart) and uploaded it below, do you experience a delay beyond this brief re-rendering?

https://www.screencast.com/t/eHLLprfFsd6

I look forward to your reply!