Bug: Anchor point gets fixed wrong when indicator attached to chart

[User1104]

Hello,

This is reproducible and here is how you can do it:

1) Open a clean chart (on a minute timeframe), attach any indicator to the chart (in the example below I did an SMA). This will only happen if the indicator is on the same panel as the chart data.

2) Draw any drawing object that goes past the current bar into the "future".


3) Change from a 30m to a 60m for example.


You will see the anchor point gets fixed wrong. If there is no indicator this works as expected, it only happens with an indicator on the chart.

Can you please confirm a bug number reported for this issue and if it will be fixed for the next 8.0.4.0 release?

Further - This was reported before and confirmed fixed, but i believe this was happening without an indicator attached, now it's still happening with an indicator attached. More details on this previous reported bug: NT8-9884

http://ninjatrader.com/support/forum/showthread.php?t=85649

Thank you!

[NinjaTrader_PatrickG]

I am able to reproduce this on my end. I'll be forwarding this to the Development Team and will update this post when I have a reference number.

Thanks for bringing this to our attention.

EDIT: This was being tracked as NTEIGHT-10968 and cannot be reproduced on the current internal build of NinjaTrader 8. I would recommend viewing the release notes when the next version of NinjaTrader 8 is released to see if this is resolved in that build:

http://ninjatrader.com/support/helpGuides/nt8/en-us/?release_notes.htm

[User1104]

Hello Patrick,

This bug has since been fixed in 8.0.3.1 and can confirm that. If I have any more issues regarding the same bug I'll update this thread - otherwise considered fixed.

Thank you for your attention in this matter.