Nt 8050 pop up messages keep popping up

[sledge]

I clicked ok to dismiss the rollover popup.

NT thinks about it, causing a spinning wheel cursor, and after 5 seconds or so, refreshes the charts, and pops up the message again.

So much for getting notice later in a few hours so I don't forget tonight. I clicked the check box to make it go away forever.

[sledge]

And the popup showed up again!

[sledge]

Locks up trying to dismiss messages.

[NinjaTrader_EricB]

Hello sledge,

Thank you for your post,

I was able to test this on my end with a test workspace loaded and am not seeing the same behavior; pressing OK clears the message without issue and when "Do not show again" is checked, the message is suppressed going forward.

Please write into to PlatformSupport[AT]NinjaTrader[DOT]Com along with your log and trace files and a link to this forum post.

Please follow the steps below to manually attach your log and trace files to your response so I may investigate this matter further.

* Open your NinjaTrader folder under Documents.
* Right click on the 'log' and 'trace' folders and select Send To> Compressed (zipped) Folder.
* Send the 2 compressed folders as attachments to this email.
* Once complete, you can delete these compressed folders.

We look forward to assisting further.