Inverse condition in the Strategy Builder

[Rober182]

Thanks for the assistance, Jesse.

[NinjaTrader_Jesse]

Hello Rober182,

Thank you for confirming.

Yes in that situation you could use 3 sets and a variable like I had described. In a first set, set the variable to false to reset it for each bar, there is no condition required just the action of setting the variable. In a second set, check your normal condition which you want the inverse of, instead of the current action, set the variable to true. In a third set, check if the variable is not true to enact the action for each bar where set 2 did not become true otherwise when set 2 is true, set 3 is not true.

I look forward to being of further assistance.

[Rober182]

Sorry for the grammar, I write from Spain and I use a translator. It is correct, if all the conditions as a whole are true, the condition does not occur. Thanks for the assistance, Jesse.

[NinjaTrader_Jesse]

Hello Rober182,

I wanted to clarify your question, I have not completely understood this as written.

Are you saying that if all of the conditions in your set are true, the condition does not happen? So the condition should happen only when the conditions are otherwise false?

If that is the case, you could do that with a user variable. Setting the variable to true when the sets conditions are true, and in a second set checking if that variable is not true to do the action. When the variable is not true, it would work inversely of the other condition. You would also need to reset the variable on each bar before this happens, so this would take 3 sets total.

I look forward to being of further assistance.

[Rober182]

Hi. I would like to know to see if you can help me. Is it possible to configure an inverse condition in the Strategy Builder? That is to say when the set of conditions established by the indicators in the Set are given, the program executes the action of NOT OPERATING, that is, not of entry to any order. I hope I have explained clearly.

Thanks for your time and regards.