I have an issue using the strategy builder. Even when making very basic and simple strategies to test its behavior, the order management is not done as expected.
For example, when a Stoch K line crosses above the D line, it should enter a long position. When the K line crosses below the D line it should enter a short position.
I found that some orders are placed where cross overs did not occur.
This is a very simple example. I have done other strategies with the builder that are far more complex, and as expected, it does not behave according to the conditions specified.
So the question, are their knowledgeable persons (on NT8) out there who can do scripting for a fee or can you recommend honest people that can assist? I am done struggling to figure something out that does not respond as specified. I am well experienced with industrial PLC programming and understand control logic, but when I use the strategy builder on NT8 and I specify certain conditions (much as industrial control logic) I am not getting the desired results.
Jacques
Comment