How to auto exit in Renko bar chart?

[RC007]

Hi,
My strategy uses renko bar for entries and calculateonbarclose set to true is a necessary requirement for the strategy to work, I want my strategy to start entering trades at 9:15 AM and exit all open positions at 3:15 PM, trade entries are working flawlessly but since renko bars can take any amount of time to complete, my exits are exceeding the time limit if current bar does not closes prior to 3:15 PM. Any body have any suggestions??

Thanks in advance!!!

[NinjaTrader_ChelseaB]

Hello RC007,

This would mean you are wanting to trigger actions intra-bar before the bar closes.

For this I would recommend adding a 1 tick series to the script. Then trigger the action on the first tick received after 9:15 AM.

Below is a link to a forum post with details about intra-bar granularity.

http://ninjatrader.com/support/forum/showthread.php?p=491297#post491297

As well as an example of a time filter.

https://ninjatrader.com/support/forum/showthread.php?t=3226

With the time filter, the tick received may not have an exact time 9:15:00. I would recommend triggering on only the first tick received with a time stamp greater than 9:15:00.

[RC007]

Thanks

Thanks ChelseaB,

I added a 5 minute bar series and wrote the exit all trade strategy under that context and during backtest its working fine, I will have to check it once the market opens today and verify it works in real time or not?

I followed these to figure it out:
1: https://ninjatrader.com/support/foru...d.php?t=107044
2: https://ninjatrader.com/support/foru...ead.php?t=5787

Thanks again for your help!!!