In NT8 there is a 'Center price on scale' option in the Data Series dialogue.
This is very helpful for me when scalp trading fast moving markets. I would like to be able to use this or some other feature like it in NT7, where my VPS for executing trades is located.
What is required for me without this 'Center price on scale' feature is this:
* I want to center the current price in the chart, so that I can stretch it vertically, to be able to make fast fine-tuned adjustments to my stop-loss and profit target when scalp trading.
So I grab the chart and while holding the Control key, I left-click and drag the chart down or up, to center it. Oftentimes there is a slow delayed action to this.
* Then I need to left-click in the right-edge of the chart and pull up to stretch it vertically. Again, oftentimes there is a slow delayed action to this.
* At that time I can then take ahold of my stop-loss and re-position it, if necessary. And/or I can then take ahold of my profit target and reposition it (if I want to take profits sooner or move my profit target further out).
But since it took me a few slow steps of trying to first center my chart and then stretch it vertically, oftentimes the price has moved quite a bit before I can finally act to do what I intended with my stop-loss and/or profit target.
I do not see a 'Center price on scale' option in the Data Series dialogue in NT7. So my question is, does it exist in NT7 and if not, is there any other way I can do what I am trying to do as outlined above?
Comment