Saving width of Market Analyzer columns

[NinjaCustomer]

please add this feature, it is so annoying to have to readjust the columns on every market analyzer tab each time the workspace is loaded.

[NinjaTrader_AlanP]

Hello NinjaCustomer,

Thank you for your note.

So I may best assist you could you please provide steps to replicate?

I modify the column width of my MA window, save the workspace, close and reopen the workspace and the column widths stick.

Also what version of NInjaTrader are you running? Under Control Center>Help>About.

I look forward to your reply.

[NinjaCustomer]

happens to me everytime I load the workspace I think.

but the problem column is the intstrument column on the far left.

I don't think there are problems with the other columns.

Basically it is wide enough to display all the 2 letter contracts but FDAX 06-18 is not quite wide enough.

And for CFDs like @USDOLLAR it also gets cut off (in the middle of the A)

probably you don't notice this because most instrument names are shorter.

@EURUSD fits

there is a chance that I just don't save my workspace after adjusting the columns but I'm pretty sure I remember doing that a couple of times before.

[NinjaTrader_AlanP]

Hello NinjaCustomer,

I adjusted the instrument column so that its barley visible as well as very wide, saved and reloaded between both and am not able to replicate.

If you could please test on your end, saving between the workspace reload, as well as provide your NinjaTrader version that would be helpful.

I look forward to your reply.