|
<< Click to Display Table of Contents >> SharpDX.Direct2D1.GeometrySink.Close() |
|
SharpDX.Direct2D1.GeometrySink.Close()
|
<< Click to Display Table of Contents >> SharpDX.Direct2D1.GeometrySink.Close() |
|
Disclaimer: The SharpDX SDK Reference section was compiled from the official SharpDX Documentation and was NOT authored by NinjaTrader. The contents of this section are provided as-is and only cover a fraction of what is available from the SharpDX SDK. This page was intended only as a reference guide to help you get started with some of the 2D Graphics concepts used in the NinjaTrader.Custom assembly. Please refer to the official SharpDX Documentation for additional members not covered in this reference. For more seasoned graphic developers, the original MSDN Direct2D1 and DirectWrite unmanaged API documentation can also be helpful for understanding the DirectX/Direct2D run-time environment. For NinjaScript development purposes, we document only essential members in the structure of this page. |
Closes the geometry sink, indicates whether it is in an error state, and resets the sink's error state.
(See also unmanaged API documentation)
Note: Do not close the geometry sink while a figure is still in progress; doing so puts the geometry sink in an error state. For the close operation to be successful, there must be one EndFigure() call for each call to BeginFigure(). After calling this method, the geometry sink might not be usable. Direct2D implementations of this interface do not allow the geometry sink to be modified after it is closed, but other implementations might not impose this restriction. |
This method does not return a value
<GeometrySink>.Close()
This method does not accept any parameters