I am testing NT8 for a while now and encountered the following two problems even in RC2!
I have six windows open 3 over 3 others. So 3 behind and 3 before (on the befores Always on top checked). When I rightclick on one of the behind charts to open e.g. Indicators and close it back. The before window (Always on top checked) becomes transparent. Only the frame stays. I can make it visible again if i uncheck and then recheck "Always on top", or maximize and then miminize it back to original size. To do this every time I place an order is really annoying.
Other problem is that my stop limit order doesn't get filled as it used to in NT7.
I use StopLimit order with -2 offset setting. So when price climbs (BuyStopLimit) up and reaches Stop price it should be filled BuyLimit if drops back 2 ticks.
Same SellStopLimit:
So when price drops (SellStopLimit) down and reaches Stop price it should be filled SellLimit if climbs back 2 ticks.
Every time i try this, an error message pops up saying once for BuyStopLimit (Limit price cannot be lower than stop price) and for SellStopLimit (Limit price cannot be higher than stop price) Which is stupid concidering this is the whole purpose of StopLimit, I believe!
Thanks!
Comment